![]() Connectors and harnesses are well made and fit tightly. If the bracket does slide around, a small hook-n-loop pad helps. Once the bracket is assembled and mounted up, everything stays in place. The AC/DC North American standard charger is larger than some but at least each user gets one one for travel and one for home, or one for each user.ĭespite its small size overall and reduced frontal area, the five controls are still easy to access and use, mainly due to the tactile button pads and an easy-to-remember layout. Obviously some channelization is happening and it would also seem that the device(s) in question are not managing audio correctly for some reason.Īs stated in the XBi2 evaluation, the solution or workaround suggested by Chatterbox is to pass on the Bluetooth from the Garmin and use a compatible BTA (like the iCombi AG12) with the zumo and thus address both situations experienced.Įach system is individually packaged and everything is well secured inside the molded shells. When GPS navigation is active, this background MP3 stream will stop but resume when the navigation audio session ends. However, it continues and both parties can hear it, although it is very weak. In essence, once the headset intercom is activated and based on headset priorities, this audio should be muted. If the MP3 player on the zumo is being used as an audio stream by one user and if the intercom is activated by either party, the active audio stream from the zumo continues and is therefore heard (weakly) by both parties. Given the “bleed-over” issue found with the XBi2 systems when using a Garmin zumo 550 and the intercom, I tried to recreate this situation with the XBi units. The lowest and highest volume settings are announced by a short double tone in the headset. Some distortion can be induced, but only when the external device is ‘cranked up’, something that the Chatterbox unit has little control over.Īt highway speeds or in heavy urban traffic the intercom was perfectly useable without having to crank the volume to its maximum setting. Only on the highest audio setting can a trace of distortion be heard, usually during Intercom use and some of this can be traced to the active feedback loop in the system. Music from higher powered peripheral devices that users typically carry today is faithfully reproduced. The headset does not have the absolute fidelity of higher priced systems, but compared to the other brands on hand these are near the top: correct placement is everything. ![]() The unit will switch itself off once the minimum voltage level is reached. When the batteries are being recharged, the charging LED is Red and the module LED is Blue and when the charging is complete, the Red LED changes to Green and the module LED goes out.īattery level status can be ascertained visually by using the Power button to activate a status sequence, or more directly by the alarm beeps that will sound in the headset once voltage drops below a certain level. Like the XBi2 units, battery life falls within the timeframe identified in the guide. Chatterbox XBi system consists of the intercom module and either an open- or full-face headset (each must be purchased separately).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |